Post coordinates

Click the "Export post coordinates" button in the toolbar to enter the "Post coordinate" interface.

Create pile

As shown in the figure below, when no array is selected, the indicator light on the right indicates the status of pile position creation for all arrays. Create all=>green, partially created=>yellow, not created=>red, When selecting a array, it indicates the creation status of the pile positions for that array.

It is necessary to create and set up each used array one by one.

To ensure performance, the length of the displayed columns for each type of array is fixed and may pass through the ground. When calculating the length, it will be calculated according to the actual setting.

Post type

"Single post" or "Double post" are supported.

E-W Distance D1

When selecting "On array surface", it is the distance on the array surface; When selecting "On horiz. ​surface", it is the projection distance of the horizontal plane.

Front-Rear Distance D2

Note that "Front-Rear Distance D2" by default refers to the distance on the surface of the arrays (as shown in the figure below).When selecting "On horiz. ​surface", the corresponding "Front-Rear Distance D2" on the arrays plane is equal to the input value/cos (nominal tilt).

Pile and post

"Post length fixed" or "Pile above ground fixed" are supported.

Export post coordinates

Check the "Only create point" option. At this time, only the position points of the posts on the array will be generated, and the solid post models will not be created.

Click "Export central point" to export only the center coordinates of each array.

Click the "Export" button at the bottom of the interface to export the pile coordinates of the entire project.

When exporting, check whether each type of array has created posts (or Only create point) . If not, the software will prompt the users: Pile position not fully created.

Find pile

When selecting "Post length fixed"

When selecting "Post length fixed", the pile length can be filtered. Click the "Find" button, and a pop-up interface will appear to select the array that needs to be filtered.

After confirmation, select the pile length parameters that need to be filtered on the interface, and click filter.

After filtering, click on the interface to display annotations to view detailed pile length information.

When selecting "Pile above ground fixed"

When selecting "Pile above ground fixed", the column length can be filtered.

"Rear pile length" and "Max rear pile length difference": Any pile in the rear row with an exposed length outside the set range or a pile length difference exceeding the set value will be selected.

"Front pile length" and "Max front pile length difference": Any pile in the front row with a length exposed to the ground outside the set range or a pile length difference exceeding the set value will be selected.

"Max pile length difference": the difference between the longest pile and the shortest pile (both referring to the length exposed to the ground) in a array.